counting waves with Awesome Oscillator
8件の返信
counting waves with Awesome Oscillator
Hello, I’m looking for a way to count the up waves (like elliott waves) and if the parameter drops close to the long position. Example: 1. wave 1 high, 2. wave high and now period lower than high 2. wave. I use the Awesome Oscillator for it.
Is there a way to analyze and count the waves?
Example: Go long if Awesome oscillator cross over zero and now: close long position after the high of the 1st wave (X marked)
(If the new period is lower than the high.)
Does anyone have an example or solution for that?
0
こんにちは,
it can be easy I presume. Can you mark on the screenshot where you would like to exit? I am not sure
0
There is an easy way how to count “waves” using Lowest / Highest function. See example attached
1
Hello, I have improved the idea because the indicator is too slow.
I have reversal points and i want to count them:
The low as a variable: MA3 [1] is larger than MA3 [2] and MA3 [2] is smaller than MA3 [3]
The high as a variable: MA3 [1] is smaller than MA3 [2] and MA3 [2] is larger than MA3 [3].
Now I want to count the highs, how many highs are above the SMA13.
If 2 highs are above the SMA13 as a variable and then MA3 gets smaller, I want to close the long position.
How could you realize that?
thanks for your help
0
It can be done as well. Is the MA3 a moving average (3) ?
Will make an example on this
0
Yes, the MA3 mean the simple moving average 3
0
hello tomas, you have an example on this above ?
regards
0
Hello, how can i reset the longBreakCounter to 0 ?, so the EA is waiting for the next LONG Signal ?
in my Go Long Rule, the Counter is under the max value (see Picture)
My Value for reset can be SMA12 under SMA26.
How can i do this ?
ありがとう
0
こんにちは,
you need to add a new action “Assign Variable” and set LongBreakCouter to 0. Let me know if any questions
You can send your project to [email protected] or attach here, I will check
0
8件の返信を表示中 - 1 - 8件目 (全8件中)