IS this EL’s code right generated by SQ3.8?
1 replies
eastpeace
11 years ago #113330
Hello, Mark and everybody,
One strategy generated by SQ looks good, could get acceptable profit with little retracement.
entry conditions in Pseudo Source Code is :
LongEntryCondition = (Close(15) Closes Below Ichimoku(9,26,52,Senkou Span A))
ShortEntryConditon = (Close(15) Closes Above Ichimoku(9,26,52,Senkou Span B))
And in TradeStation’s language, the entry condition is :
LongEntryContion=((Open[14]>SQIchimoku(9,26,52,2)) and(Close[14]<SQIchimoku(9,26,52,2)));
ShortEntryContion=((Open[14]<SQIchimoku(9,26,52,3))and(Close[14]>SQIchimoku(9,26,52,3)));
I am not sure about PS code,” Closes Below/Above”, but in TS’s language the entry conditions are in One bar’s signal, and when gap happened, how does it work?
So, I think “close[15]>SQIchimoku and close[14]<SQIchimoku” would be better with more flexibility, (or “close[16]>Ichimoku and close[15]<Ichimoku”, I an not sure) .
But unfortunately, I get more different and worse equity cure than SQ’s results in MultiCharts , even using the code given by SQ.
And most time, the strategy in Multicharts get more different equity curve (I am sure the point value, pip/tick size setting is right).
Could anyone who use SQ and Multicharts, or TradeStation tell me your SQ’s code is friendly to MC / TS, or not?
0
Mark Fric
11 years ago #128789
Hello,
there are more meanings of something closes above/below something. It is obvious or indicators, but for close there are two alternatives as you described.
We use the alternative that open of the bar is above the value and close is below the value (for close below).
As for different results in MultiCharts – I tested it only with Tradestation, but I assume it should be the same in MultiCharts.
The results in SQ and Tradestation should be almost exact. Could you post here or send me by email a strategy (.str file) that gives you very different results? I can look at it.
Mark
StrategyQuant architect
0
Viewing 1 replies (of 1 total)