CFD trading (natural Gas) Tick Size / Tick Step and point Value
3 replies
bla0018
4 years ago #279885
Hello,
I’m trying to create strategies for natural gas. I have tried default values and also tried my best to get these values using my broker specs but I cant seem to get SQX to match backtest. SQX shows profitable but when I run it on backtest it completely fails. I check the———– Use Tick size from SQ (for CFDs) ———– in inputs before running backtest.
Im backtesting on IC markets and have tried both IC market data and duscaopy both without success
0
bla0018
4 years ago #279892
Here is my specs from IC markets
0
aeroknight
4 years ago #279921
I did not try with XNG specifically but I found using Duckascopy data with SQx did not match IC Markets. SQx p/l calculations were all wrong (showed much higher than reality for the lot size).
I was able to get the profit / loss calculations correct in SQx by changing the Instrument (USA500IDXUSD) properties to the following values:
Point value: 1
Pip/Tick Size: 0.1
Pip/Tick Step: 0.1
Default spread: 5
I did not check the ‘Use Tick size from SQ (for CFDs)’ flag – I have no idea what it would do.
0
Tomas Matejka
4 years ago #279940
The “UseSQTickSize” parameter allows you to override the current chart settings the EA is applied to. For example current chart setting for the pip is 0.01 while the strategy was developed using pip = 0.1. To run the such a strategy properly in MT you can enable the parameter and set the MainChartTickSize to the SQ value
0
Viewing 3 replies - 1 through 3 (of 3 total)