Parameter Tabs
2 replies
gregh
1 year ago #280908
I am trying to set-up a very narrow build. I am confused about the parameter tabs under the Building Blocks tab. I only want to randomize and use the values configured under the Parameters Values tab. I do not want to use any of the Parameter Sets, under the Parameter Sets tab.
My question is how do I configure SQX to only use what I configure in the Parameter Values tab, and not use anything from the Parameter Sets tab?
I tried setting the Weight of the Parameters Sets to 0 but then nothing runs. I tried setting just one Set to 1. Things run but all my configuration under the Parameters Values tab are ignored.
Screenshots of both Tabs are attached.
tomas262
1 year ago #280942
Hi Gregh,
can you better save your builder configuration and share with me? You can upload into forum post
gregh
1 year ago #280945
Tomas, my question is more general about the tabs then specific to a build. I will do as you ask but do you not understand my question about the tabs?
Viewing 2 replies - 1 through 2 (of 2 total)